Well done! i just did a holder like this from the same source, and the result is yet is a little below than expected. hope to improve in the next ones. Just a question, your valves get really really still on the support? if so, which bold measure circumference you used? Because some of my valves, apart from holding a key, seem a little loose if a touch it. Thanks in advance and congratz. MArio
I don't really understand what you mean, but my valves are not that sturdy either, in the end they're only supposed to hold keys right?! And I didn't use any bolts. Sorry that I can't help you with that.
2 comments → BIKE KEY HOOKS
Well done! i just did a holder like this from the same source, and the result is yet is a little below than expected. hope to improve in the next ones. Just a question, your valves get really really still on the support? if so, which bold measure circumference you used? Because some of my valves, apart from holding a key, seem a little loose if a touch it. Thanks in advance and congratz. MArio
I don't really understand what you mean, but my valves are not that sturdy either, in the end they're only supposed to hold keys right?! And I didn't use any bolts. Sorry that I can't help you with that.
Post a Comment